STRAW AND HAY SHREDDER WITH CONVEYOR SS-D180
The shredder is designed for shredding straw or hay pressed in rolls. In certain cases, after obtaining the manufacturer’s permit or testing, it is possible to shred square or rectangular pressed bundles. Required fraction of the shredded product at the output is possible after selecting a sieve of a certain throughput from the range offered by the manufacturer. In case product fractions of a smaller size are needed, insert a finer sieve, and vice versa.
The finer the sieve is, the higher is the kg/h throughput of the shredder, and vice versa. The user should select these parameters according to desirable result of throughput and fraction ratio.
The shredder with the conveyor is adjusted for the operations described in the manual in usual operation conditions. If the shredder is used for other works or in potentially dangerous conditions, the manufacturer assumes no responsibility for the consequences of operation. In case of adverse conditions of operation, it is necessary to contact the manufacturer of the equipment or its representative.
CE Certificate.
Technical Data of Shredder
Capacity | 500 – 1200 kg/h |
Shredding fraction | 10 – 35 mm |
Humidity of raw material | <20 % |
Fitting roll diameter max | 1700 mm |
Fitting roll length max | 1200 mm + 600 mm |
Noisiness | 77,8 dB +/- 5dB |
Output pipe diameter | 200 mm |
Length | 2300 mm |
Width | 2200 mm |
Height | 2350 mm |
Weight | 750 kg |
Electricity | 380V 50Hz |
Power | 38,1 kW |
Current | 63A |
Technical Data of Conveyor
Length | 4000 mm |
Width | 1650 mm |
Height | 1000 mm |
Weight | 300 kg |
Electricity | 380V 50Hz |
Power | 1,1 kW |
Current | 2,78 A |